THE COMPOSITE CONSOLIDATION OF SUCKER RODS BY METALLIZED COATING AND GLASS-PLASTIC ISOLATION

Authors

  • Б. В. Копей ІФНТУНГ ; 76019, м . Івано - Франківськ , вул . Карпатська , 15; тел . (03422) 42166
  • І. І. Стеліга ІФНТУНГ ; 76019, м . Івано - Франківськ , вул . Карпатська , 15; тел . (03422) 42166
  • В. Б. Копей ІФНТУНГ ; 76019, м . Івано - Франківськ , вул . Карпатська , 15; тел . (03422) 42166

Keywords:

sucker rod, glass-plastic, metallized coating

Abstract

Pumping oil with the help rod pump sucker rods are often damage and this damage greatly influences oil industry enterprise. To increase the endurance of sucker rods which are used in corrosive-active environment the composite consolidation of sucker rods by metallized coatings and glass-plastic isolation is proposed. To consolidate new sucker rods and repair used sucker rods the technology of zinc-epoxy-gum elastic coating is worked out. The results of research showed that wear resistance of these coatings is high during friction of sucker rod columns against the surface of pump-compressor pipe. Besides, the given coating reduces the possibility of resin-paraffin materials sediment on the sucker rods appreciably, that allows to preserve the proper regime of oil pumping for some time. Besides, the given coating reduces the possibility of resin-paraffin materials sediment on the sucker rods appreciably, that allows to preserve the proper regime of oil pumping for some time.

References

1 Опыт упрочнения новых и восстановления ресурса бывших в эксплуатации насосных штанг / Б.В. Копей, Я.Т. Федорович, Ю.С. Сычов [та ін.] // Розвідка та розробка нафтових та газових родовищ: Респ. міжвід. наук.-техн. зб.– 1991.– Вип. 28.– С. 104-110.
2 Инструкция по технологии нанесения покрытий из полимерных порошковых материалов на насосные штанги [Текст] : РД-39-0147585-007-87 : ТатНИПИнефть, утв. М-вом энергетики Рос. Федерации 13.04.87 : ввод. в действие с 01.11.87

Published

20.11.2009

How to Cite

Копей, Б. В., Стеліга, І. І., & Копей, В. Б. (2009). THE COMPOSITE CONSOLIDATION OF SUCKER RODS BY METALLIZED COATING AND GLASS-PLASTIC ISOLATION. Oil and Gas Power Engineering, (2(11), 5–11. Retrieved from https://nge.nung.edu.ua/index.php/nge/article/view/195

Issue

Section

PHYSICAL-TECHNICAL PROBLEMS OF ENERGY CARRIERS RECOVERY

Most read articles by the same author(s)

1 2 3 > >>